HP ProDesk 400 G4 Base Model Microtower PC Manual de usuario descargar pdf (Pagina 17)

Removing an optical drive bezel blank

On some models, there is a bezel blank covering the slim optical drive bay. Remove the bezel blank before

installing an optical drive. To remove the bezel blank:

1. Remove the computer access panel and front bezel. See Removing the computer access panel on page 6

and Removing the front bezel on page 8.

2. To remove the bezel blank, press upward on the bottom tab and press downward on the top tab on the

side of the blank (1), rotate the blank o the front of the bezel (2), then remove from the front bezel

panel.

Replacing the front bezel

Insert the three hooks on the bottom edge of the bezel into the rectangular holes on the chassis (1), and then

rotate the top side of the bezel onto the chassis (2) and snap it into place.

Removing an optical drive bezel blank 9

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 50 51

Sin comentarios

HP ProDesk 400 G4 Base Model Microtower PC Manual de usuario Pagina 17