HP ProDesk 400 G4 Base Model Microtower PC Manual de usuario descargar pdf (Pagina 29)

7. Press the release lever on the back of the drive (1), and then slide the drive through the front bezel (2).

Installing a 9.5 mm slim optical drive

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as compact discs or USB ash drives, from the computer.

3. Turn o the computer properly through the operating system, then turn o any external devices.

4. Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as

the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to

the internal components of the computer.

5. Remove the computer access panel. See Removing the computer access panel on page 6.

6. If you are installing a slim optical drive in a bay covered by a bezel blank, remove the front bezel and

then remove the bezel blank. See Removing an optical drive bezel blank on page 9 for more information.

7. Follow the instructions for removing the optical drive if one was installed. Refer to Removing a 9.5 mm

slim optical drive on page 20.

Removing and installing drives 21

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 50 51

Sin comentarios

HP ProDesk 400 G4 Base Model Microtower PC Manual de usuario Pagina 29