HP HyperFabric Guía de usuario descargar pdf (Pagina 171)

Troubleshooting HyperFabric

Replacing a HyperFabric Switch

Chapter 6 157

Replacing a HyperFabric Switch

If you need to replace a faulty HyperFabric switch, follow these steps:

Step 1. If you do not have an HA environment, stop HyperFabric on all nodes

that are connected to the faulty switch. (See “Stopping HyperFabric” on

page 128.)

If you have an HA environment with two switches (where the backup

switch will have taken over when the ﬁrst switch failed), disconnect all

cables attached to the faulty switch.

Step 2. Install a new switch. (See “Installing HyperFabric Switches” on

page 57.)

Step 3. If you stopped HyperFabric on all nodes connected to the switch (in step

1), start it on those nodes. (See “Starting HyperFabric” on page 109.)

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 189 190

Sin comentarios

HP HyperFabric Guía de usuario Pagina 171