HP HyperFabric Guía de usuario descargar pdf (Pagina 66)

Installing HyperFabric

Installing the Software

Chapter 352

The commands and ﬁles used to administer HyperFabric typically have a

preﬁx of clic_. CLIC stands for CLuster InterConnect, and it is used to

differentiate those HyperFabric commands/ﬁles from other

commands/ﬁles. For example, the HyperFabric command clic_init is

different from the HP-UX init command.

Each of the ﬁles shown in Figure 3-1 above is brieﬂy described below:

• /etc/opt/resmon/dictionary/clic_01

The HyperFabric dictionary ﬁle for the Event Monitoring Service

(EMS).

• /etc/rc.config.d/clic_global_conf

The global conﬁguration ﬁle, which contains the IP addresses for

each adapter and each HyperFabric switch (if any) in the fabric.

• /sbin/init.d/clic

The system boot startup script for the HyperFabric management

process.

• /var/adm/clic_ip_drv.trc

One of the software’s trace ﬁles. This ﬁle is created when the

clic_diag -D TCP_IP command is run.

• /var/adm/clic_ip_drv.trc0

One of the HyperFabric software’s trace ﬁles. This is the primary ﬁle

that is created when the clic_diag -C TCP_IP command is run.

• /var/adm/clic_ip_drv.trc1

One of the HyperFabric software’s trace ﬁles. This ﬁle is created

when the clic_diag -C TCP_IP command is run, and the primary

trace ﬁle (clic_ip_drv.trc0) becomes full.

• /var/adm/clic_log

The global log ﬁle that is updated by the HyperFabric management

process.

• /var/adm/clic_log.old

The backup copy of the log ﬁle that is created when the log ﬁle grows

larger than 100 Kbytes.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 189 190

Sin comentarios

HP HyperFabric Guía de usuario Pagina 66