Hp Integrity rx4610 Server Manual de usuario descargar pdf (Pagina 116)

Chapter 10 Configuring the HP Server

108

monitor boot progress in two different places: the video display and the

LCD display on the Front Panel. Information appears in the LCD display

first.

NOTE To enter the BIOS Setup Utility you must immediately start

pressing <F2> repeatedly after you first power on the server.

Doing so interrupts the boot process and allows you to use the

utility. For more information on entering and using the utility,

refer to “Using BIOS Setup” in this chapter.

2. POST begins running. POST checks the drive carriers, processors,

memory, keyboard, and most installed peripheral devices. During the

memory test, POST displays the amount of memory it is able to access and

test. The length of time needed to test memory depends on the amount of

memory installed. POST is stored in flash memory.

3. The LCD displays boot progress as follows:

Boot,First Row Test (should always be 64MB)

Base Memory Test (2GB max)

Ext Memory Test (will report out if enough memory

is available)

CMOS Test

Keybrd Bat Test

Initialize Timer

PCI Bus Scan

Initialize Video

Keyboard Test

Initialize IDE

Serial Test

Prepare to Boot

Processor Speed

4. Video appears on the monitor attached to the system and begins to display

boot progress.

◊

◊◊

◊ AMI BIOS banner: displays the loaded versions of the BIOS, PAL,

SAL, and EFI.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 248 249

Sin comentarios

Hp Integrity rx4610 Server Manual de usuario Pagina 116