Hp ProLiant BL25p G2 Server-Blade Manual de usuario Pagina 35
- Pagina / 99
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Cabling 35
2.
Connect the local I/O cable to the I/O port on the server blade.
CAUTION: Disconnect the local I/O cable when not in use. The port and connector do not provide a
permanent connection. Rear iLO 2 connector performance degrades when the local I/O cable is connected,
even if the iLO 2 connector on the cable is not in use.
CAUTION: Before disconnecting the local I/O cable, observe the following guidelines:
• Completely log out of the current iLO 2 session before disconnecting from the iLO 2 port. Do not remove
the local I/O cable when the UID LED is flashing.
• Always squeeze the locking buttons on the side of the server blade connector before disconnecting from
the I/O port. Failure to do so can result in damage to the equipment.
Connecting locally to a server blade with video and USB
devices
Use the local I/O cable to connect a monitor and any of the following USB devices:
• USB hub
• USB keyboard
• USB mouse
• USB CD/DVD-ROM drive
• USB diskette drive
Numerous configurations are possible. This section offers two possible configurations.
Accessing a server blade with local KVM
CAUTION: Disconnect the local I/O cable when not in use. The port and connector do not provide a
permanent connection. Rear iLO 2 connector performance degrades when the local I/O cable is connected,
even if the iLO 2 connector on the cable is not in use.
NOTE: For this configuration, a USB hub is not necessary. To connect additional devices, use a USB hub.
1. Connect the local I/O cable to the server blade ("Local administration using iLO 2" on page 34).
2. Connect the video connector to a monitor.
- User Guide 1
- Audience assumptions 2
- Contents 3
- Contents 4 4
- Contents 5 5
- Component identification 6
- Front panel components 7
- Rear panel components 8
- System board components 9
- DIMM slot numbering 10
- System maintenance switch 10
- Internal USB connector 11
- Local I/O cable 11
- Operations 13
- Remove the server blade 14
- Remove the access panel 14
- Operations 15 15
- Overview 16
- Verifying system components 16
- Connecting to the network 17
- Installing a server blade 20
- Completing the configuration 21
- Processor option 22
- Hard drive option 27
- Memory option 28
- Installing DIMMs 29
- NIC mezzanine option 30
- Cabling 34
- Configuration and utilities 38
- Network-based PXE deployment 39
- Deployment infrastructure 40
- Static IP bay configuration 41
- Deployment methods 41
- PXE deployment 42
- CD-ROM deployment 42
- Diskette image deployment 43
- SAN configuration 44
- Configuration tools 45
- HP ROM-Based Setup Utility 46
- Array Configuration Utility 47
- Management tools 48
- ROMPaq utility 49
- Erase Utility 49
- HP Systems Insight Manager 50
- Management Agents 50
- HP Control Tower 52
- Redundant ROM support 52
- Networking tools 53
- Diagnostic tools 54
- Array Diagnostic Utility 55
- Web-Based Enterprise Service 55
- Open Services Event Manager 55
- Keeping the system current 56
- Care Pack 57
- Troubleshooting 58
- Important safety information 59
- Symptom information 60
- Service notifications 61
- Loose connections 61
- Troubleshooting flowcharts 62
- General diagnosis flowchart 63
- Symptoms: 65
- POST problems flowchart 67
- Possible problems: 68
- Faulty KVM device 68
- Faulty video device 68
- OS boot problems flowchart 69
- Troubleshooting 71 71
- Possible causes: 72
- Redundancy failure 72
- Introduction 73
- Troubleshooting 74 74
- Battery replacement 75
- In this section 76
- FCC rating label 76
- FCC logo, United States only 77
- Modifications 78
- Japanese notice 79
- BSMI notice 79
- Korean notice 80
- Laser compliance 80
- Battery replacement notice 80
- Electrostatic discharge 82
- Specifications 83
- Technical support 84
- Customer Self Repair 86
- Technical support 87 87
- Reparo feito pelo cliente 88
- Technical support 89 89
- Technical support 90 90
- Technical support 91 91
- Acronyms and abbreviations 92
- Version Control Agent 95
- Workload Management Pack 95
- Index 96 96
- Index 97 97
- Index 98 98
- Index 99 99
Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant BL25p G2 Server-Blade
(116 paginas)
(187 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.057 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales