Hp ProLiant DL360e Gen8 Server Manual de usuario Pagina 54
- Pagina / 114
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Hardware options installation 54
9.
Power up the server (on page 16).
After installing the DIMMs, use RBSU ("HP ROM-Based Setup Utility" on page 81) to configure the memory
protection mode.
Processor option
The server supports single-processor and dual-processor operations.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP Product Bulletin website (http://www.hp.com/go/productbulletin).
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION: To prevent possible server overheating, always populate processor socket 2 with a
processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.
In a multiprocessor configuration, to optimize system performance, HP recommends balancing the total
capacity of the DIMMs across the processors.
To install the component:
1. Power down the server (on page 16).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 16).
o Remove the server from the rack (on page 17).
4. Remove the access panel (on page 18).
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Component identification 6
- Front panel LEDs and buttons 7
- Rear panel components 8
- Rear panel LEDs and buttons 8
- System board components 9
- Item Description 10
- DIMM slot locations 11
- System maintenance switch 11
- NMI functionality 11
- Drive numbering 12
- Drive LED definitions 12
- FBWC module LED definitions 13
- Fan locations 15
- Operations 16
- Remove the access panel 18
- Install the access panel 19
- Remove the PCI riser cage 19
- Install the PCI riser cage 20
- Optimum environment 21
- Temperature requirements 22
- Power requirements 23
- Server warnings and cautions 24
- Rack warnings 25
- Installing hardware options 26
- Registering the server 28
- Introduction 29
- Security bezel option 29
- Front video adapter option 29
- Drive options 30
- Installing a hot-plug drive 31
- Drive cable options 32
- Mini-SAS cable option 34
- Mini-SAS Y-cable option 35
- Controller options 37
- Optical drive option 41
- Hot-plug fan module option 43
- Fan population guidelines 44
- Memory options 47
- HP SmartMemory 48
- DIMM identification 49
- Memory protection modes 50
- Memory population guidelines 51
- Installing a DIMM 53
- Processor option 54
- Expansion board options 59
- GPU power cable option 60
- Cabling 69
- Eight-bay SFF drive cabling 71
- Optical drive cabling 75
- GPU power cabling 76
- Server mode 77
- HP product QuickSpecs 77
- HP iLO Management 77
- Active Health System 78
- Intelligent Provisioning 79
- HP Insight Diagnostics 80
- HP Service Pack for ProLiant 81
- HP ROM-Based Setup Utility 81
- Using RBSU 82
- Auto-configuration process 82
- Boot options 83
- Configuring AMP modes 83
- Utilities and features 84
- ROMPaq utility 85
- Automatic Server Recovery 85
- USB support 85
- Redundant ROM support 85
- Keeping the system current 86
- ProLiant servers 87
- Troubleshooting 88
- System battery replacement 89
- Regulatory information 91
- Electrostatic discharge 92
- Specifications 93
- Specification Value 94
- Support and other resources 98
- Customer Self Repair 100
- Reparo feito pelo cliente 102
- Acronyms and abbreviations 106
- Documentation feedback 110
- Index 111 111
- Index 112 112
- Index 113 113
- Index 114 114
Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant DL360e Gen8 Server
(484 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.039 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales