HP SmartStream Print Controller for HP Designjet T3500 Production eMFP Manual de usuario descargar pdf (Pagina 36)

Nesting preferences

●

Nest width: The maximum total width of the nested pages. Roll width (auto) by default, which uses the

width of the widest roll loaded into the printer.

NOTE: If there is a page in your document wider than the nest width you have selected, the width of that

page is used as the nest width.

●

Sheet length: The printer is allowed to cut the paper into sheets of this length or greater. Minimum by

default, which means that the printer is allowed to cut the paper into sheets of any length. Or you can

choose to

Disable cutter.

●

Add cutting lines: If checked, the application adds cutting lines to all pages (unchecked by default).

●

Gap: The spacing between pages, from 0 to 100 mm (3 mm by default).

●

Add printer margins: If checked, the application avoids trying to print in the printer margins (checked by

default).

NOTE: When you nest a job, the paper type and print quality must be the same for all pages in the job.

In the preview (see Print preview on page 40), you can see how your pages will be nested, and you can move

individual pages in the preview if you like. The order and positioning of pages that you set in the preview will be

respected in the nal print.

30 Chapter 4 Job preparation ENWW

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 82 83

Sin comentarios

HP SmartStream Print Controller for HP Designjet T3500 Production eMFP Manual de usuario Pagina 36