HP Firewall Series Manual de instalación descargar pdf (Pagina 18)

Connecting Ethernet cables

Connecting a copper Ethernet cable

Follow these steps to connect a copper Ethernet cable:

Step1 Plug one end of an Ethernet twisted pair cable into the copper Ethernet port (RJ-45 port) to be connected

on the firewall.

Step2 Plug the other end of the cable into the RJ-45 port of the peer device.

Step3 After the firewall is powered on, check the status LED of the port. If the LED is solid green, you can be sure

that the link is connected. For more information about the LED status, see the chapter “Appendix B

LEDs.”

Connecting an optical fiber

Before connecting the firewall to the network, you must install a transceiver module to the firewall, and

then insert the fiber connector to the transceiver module. The A-F1000-A-EI/A-F1000-S-EI firewall

supports LC connectors only.

WARNING!

When connecting an optical fiber, note the following guidelines:

• Never bend or curve a fiber when connectin

it. After a fiber is installed well, the bend radius must be

not less than 10 cm (3.94 in).

• Keep the fiber end clean.

• Make sure that the fiber connector matches the transceiver module.

• Before connecting a fiber, make sure that the optical power at the receiving end does not exceed the

upper threshold of the optical receive power of the transceiver module. Otherwise, the transceiver

module may be damaged. For the optical power of a transceiver module, see the chapter “Appendix

Technical specifications.”

Follow these steps to connect optical fibers:

Step1 Remove the dust plug of the SFP port.

Figure 11 Remove the dust plug

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Sin comentarios

HP Firewall Series Manual de instalación Pagina 18