HP Firewall Series Manual de instalación descargar pdf (Pagina 39)

• Use the reboot command to reboot a firewall.

• Enable the scheduled reboot function at the CLI. You can set a time at which the firewall can

automatically reboot, or set a delay so that the firewall can automatically reboot within the delay.

• Power on the firewall after powering it off, which is also called hard reboot or cold start. Powering

off a running firewall causes data loss and hardware damages, and therefore is not recommended.

Perform the following operation to reboot the firewall immediately:

To do… Use the command… Remarks

Reboot the firewall

immediately

reboot

Required

Available in user view

Perform the following operation to enable the scheduled reboot function:

To do… Use the command… Remarks

Enable the scheduled reboot

function and specify a specific

reboot time and date

schedule reboot at hh:mm [ date ]

Enable the scheduled reboot

function and specify a reboot

waiting time

schedule reboot delay { hh:mm |

mm }

Use either command

The scheduled reboot function is

disabled by default.

Available in user view

CAUTION:

• If the main host software file is not specified, do not use the reboot command to reboot the firewall. In

this case, you should specify the main host software file first, and then reboot the firewall.

• The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the device

prompts “REBOOT IN ONE MINUTE” and reboots in one minute.

• If you are performing file operations when the device is to be rebooted, the system does not execute the

reboot command for security.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 59 60

Sin comentarios

HP Firewall Series Manual de instalación Pagina 39