HP EliteDesk 800 G1 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 26)

• Adding new users and passwords

• Updating ME firmware

WebUI support is enabled by default for Manual mode setup and configuration.

Connecting with the WebUI in Manual mode

1. Power on an Intel AMT system that is in its operational phase.

2. Invoke a web browser on a separate system (such as a management PC) that is on the same subnet as the Intel AMT

system.

3. Connect to the Intel AMT system using the IP address and port specified in the MEBx.

– By default, the port is 16992

– If DHCP has been specified, then use the Fully Qualified Domain Name (FQDN) for the ME, which is a combination of

the hostname and domain as in the following examples:

• IPv4 address: http://192.168.0.1:16992

• Host names (see Host Name) http://hpsystem.hp.com:16992

• IPv6 address: http://[2001:ABC::ABC]:16992

The remote system makes a TCP connection to the Intel AMT system and accesses the top-level web page embedded

within the ME.

4. Enter your username and password. The default username is admin, while the password is the one specified during ME

setup. After login, the System Status screen appears, as shown in Figure 21.

Figure 21. The WebUI System Status screen

5. Review the system information and make any necessary changes.

Note

You can use the WebUI to change the MEBx password (see Creating a password) for the remote system.

Changing a password in the WebUI or SCS results in the creation of two passwords for Intel AMT setup and configuration,

with the new credential being known as the remote MEBx password.

The remote MEBx password only works remotely with the WebUI or SCS. The local MEBx password does not change.

If you create a remote MEBx password, you must now keep track of two passwords.

When the MEBx password is initially set in Intel AMT setup, it serves as both a local and remote password. In this scenario,

passwords are synchronized; if you create a remote password, the passwords are now out of sync.

6. Exit.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 42 43

Sin comentarios

HP EliteDesk 800 G1 Base Model Small Form Factor PC Manual de usuario Pagina 26