HP EliteDesk 800 G1 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 37)

• Partial unprovisioning

Only available for systems provisioned in Enterprise mode, partial unprovisioning returns all Intel AMT configuration

settings to their factory defaults with the exception PID, PPS, and PKI-CH settings.

This option does not reset ME configuration settings or the MEBx password.

Partial unprovisioning re-opens the network interface for six hours of “hello” message broadcasts.

Approximately a minute after you select the desired unprovisioning option, the caution shown in Figure 26 appears.

On completion, control is passed back to the Intel AMT Configuration screen. Notice that the Activate Network Access option

(Figure 8) is again available.

After return to the previous menu and exiting, the system will reboot.

Making a full return to factory default settings

F10 setup provides an option that allows you to fully unprovision the ME to factory defaults. Use the Unconfigure AMT/ME

option, which is located under the Advanced/AMT Configuration menu.

The unconfigure option clears CMOS, thus returning all MEBx settings to factory defaults; for example, the password is reset

to admin.

Following the unconfigure, the system must be setup and configured again before remote management is possible. Any

non-default certificate hashes will have to be re-applied.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43

Sin comentarios

HP EliteDesk 800 G1 Base Model Small Form Factor PC Manual de usuario Pagina 37