HP HP ProCurve Series 6600 Manual de usuario descargar pdf (Pagina 6)

Basic Settings and Operations

1.1

Switch Access

The switches in the HP ProCurve series feature several configuration interfaces - web interface, console

command line, and interactive menu. The command line and interactive menu are accessible through:

• console port (RS 232 line),

• telnet protocol

• ssh protocol

The command line which can configure all switch parameters is used in all examples below. In many ways

management is similar to the Cisco IOS configuration, although there are significant differences.

1.2

Resetting to Factory Default

The first three steps are needed only if you do not know the switch access console password. If you want to

cancel the current configuration only and you know the access password, you may omit these steps.

Find the Clear and Reset buttons on the switch. Press and hold both buttons until the Power and Fault

indicators light up.

1. Continue to hold the Clear button pressed and release the Reset button.

2. Release the Clear button when the Self Test indicator starts blinking.

3. The switch is now ready in a factory default configuration.

4. Now you need to run the following command:

# erase startup-config

and reboot the switch.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Sin comentarios

HP HP ProCurve Series 6600 Manual de usuario Pagina 6