
7
1.3
Firmware Upgrade
Firmware upgrade is a very important step. Always check if a newer firmware version has been released before
installing new firmware. The development of firmware for HP switches is quite intensive and new versions with
fixes tend to be released relatively often (about every four months). Currently switch firmware is available for
free on a website.
Recommendation:
Always look for new firmware releases for your switches. Always use the newest version available for new
installations if nothing prevents it.
The switch firmware is stored in the switch flash memory. All switches have a primary and a secondary flash
memory. Firmware updates should therefore be done using alternately the primary and secondary flash
memory. With this procedure you will always be able to return to the previous version in case of any
unexpected problems.
Recommendation:
Use primary and secondary flash memory alternately to update the switch firmware.
The following example assumes that the firmware is stored on your TFTP server and that the TFTP server is
accessible through the IP protocol from the switch. In this example the TFTP server address is 10.229.255.15
and the firmware is stored in the file hp-img/hp54xx/K_14_41.swi .
We list the flash memory contents
hp-test# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 9798890 08/27/09 K.14.19
Secondary Image : 7544081 02/26/09 K.13.58
Boot Rom Version: K.12.20
Default Boot : Primary
We verify the TFTP server accessibility
hp-test# ping 147.229.255.15
147.229.255.15 is alive, time = 1 ms
The image is now loaded into the secondary flash - confirm the operation by pressing the "y" key. The whole
operation takes a few minutes.
hp-test# copy tftp flash 147.229.255.15 hp-img/hp54xx/K_14_41.swi secondary
The Secondary OS Image will be deleted, continue [y/n]? y
....
Comentarios a estos manuales