HP Vectra VA6 Guía de usuario descargar pdf (Pagina 30)

3 Basic System Test

Overview of the Basic System Test

18 English

Overview of the Basic System Test

The basic system test is performed after hardware detection. The

purpose of the basic system tests is to verify the correct operation of

the PC’s hardware. For each detected hardware component, the test

will confirm that:

•

The component is powered-on

•

The component has been initialized for use

•

The component is operating correctly under MS-DOS.

Unlike the advanced system tests, the basic system test is done

automatically and no user input or guidance is needed. This test phase

is suitable for all types of users, including novice and non-technical

users.

Most of the PC’s components are tested during the basic system test.

To test all of the PC’s components, use the advanced systems tests.

How to Run the Basic System Test

The basic system test is performed after the hardware detection phase.

To do the basic system test, follow these steps:

Start DiagTools. To learn how to do this, refer to chapter 1, Starting

DiagTools.

Follow the instructions on the screen to proceed with hardware

detection. Hardware detection is described in chapter 2.

You will then be invited to proceed with the basic system test. Press

and follow the instructions on your screen.

NOTE The screen image may become corrupted during the basic system test.

This is normal. Do not restart your system. The image will be restored

after the test is complete.

guard.bk : guard3.fb4 Page 18 Wednesday, June 30, 1999 3:06 PM

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 95 96

Sin comentarios

HP Vectra VA6 Guía de usuario Pagina 30