HP Access Control Guía de inicio rápido descargar pdf (Pagina 21)

IP column. Click the Test button to test the connection. The Status column should display OK. Then click

Apply.

Click the Encrypt all web communication (devices) checkbox if you want to enable the HTTPS protocol for

communications between devices and the server.

Click the Use server name instead of IP (devices) checkbox for one or both of the following reasons:

●

If the server name was entered during the installation and configuration of the OPS server. See the HP

Access Control (HP AC) Install Guide for more information about the installation of the OPS server.

●

If the web service security feature Cross-Origin Resource Sharing (CORS) is enabled on FutureSmart

devices. To pull print at the device with Secure Pull Print Express, make sure the server name is added

to the CORS Trusted Sites list. To use tracking at the device with Job Accounting, make sure the server

name is listed in the CORS Trusted Sites list. To pull print at the device with Secure Pull Print, make sure

"localhost" is listed in the CORS Trusted Sites list.

Figure 4-14 CORS trusted sites

NOTE: If OPS is configured on the server and you want to change the configuration of OPS to use the server

name or the server IP address, follow the steps below:

1. Close the HP Access Control (HP AC) configuration tool.

2. Navigate to the C:\Program Files (x86)\Hewlett-Packard\OPS\config folder and open the ops.cfg file in a

text editor application. After “host=”, enter the server IP address or servername.domain.com, where

servername is the name of the server, and domain is the name of the domain. Save and close the file.

3. Navigate to the C:\Program Files\Hewlett-Packard\HP Access Control folder and delete the OPS

certificate file.

4. Go to Administrative Tools > Services and restart the OPS service. Restarting the OPS service creates a

new OPS certificate using the server name or server IP address.

5. Open the HP Access Control (HP AC) configuration tool. Go to the Settings tile > Device tab and verify that

the OPS certificate file name and the OPS server field contain the server name or server IP address.

Section 4.4 IIS tab 13

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 70 71

Sin comentarios

HP Access Control Guía de inicio rápido Pagina 21