Hp ProCurve 520wl Wireless Access Point Manual de usuario Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 191
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
Getting Started
Figure 2-8 Enter Network Password Screen
Setup Wizard
The first time you connect to an AP’s HTTP interface, the Setup Wizard launches automatically. The Setup Wizard
provides step-by-step instructions for how to configure the Access Point’s basic operating parameter, such as Network
Name, IP parameters, system parameters, and management passwords.
Setup Wizard Instructions
The first time you logon to the AP HTTP interface, the Setup Wizard launches. Follow these steps to access the
Access Point’s HTTP interface and launch the Setup Wizard:
Figure 2-9 Setup Wizard
5. Click Setup Wizard to begin. If you want to configure the AP without using the Setup Wizard, click Exit and see
Advanced Configuration.
The Setup Wizard supports the following navigation options:
Save & Next Button: Each Setup Wizard screen has a Save & Next button. Click this button to submit any
changes you made to the unit’s parameters and continue to the next page. The instructions below describe
how to navigate the Setup Wizard using the Save & Next buttons.
2-9
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 190 191

Comentarios a estos manuales

Sin comentarios