HP ProLiant Generation ML310 Especificaciones Pagina 43

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 80
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 42
Removal and replacement procedures 43
You can expand server memory by installing PC2-6400 DDR2 SDRAM DIMMs. The system supports up to
four DIMMs for a maximum of 8 GB.
For DIMM slot locations and bank assignments, see "System board components (on page 68)."
Observe the following guidelines when installing additional memory:
DIMMs installed in the server must be unbuffered DDR2 SDRAM with ECC.
If only a single DIMM is installed, it must be installed in slot 1A.
All DIMMs installed must be the same speed.
BIOS detects the DIMM population and sets the system as follows:
Single-bank mode: Single DIMM installed in one bank only
Single-bank interleaved mode: DIMMs installed in one bank with equal capacities per slot
Dual-bank asymmetric mode: DIMMs installed in both banks, but of unequal capacities per bank
Dual-bank interleaved mode: DIMMs installed in both banks with equal capacities per bank
The following table lists some, but not all, possible configurations. For best performance, HP recommends
dual-bank interleaved mode configurations.
Slot 1A Slot 2B Slot 3A Slot 4B Total memory Mode
512 MB 512 MB Single-bank
512 MB 512 MB 1 GB Single-bank interleaved
1 GB 1 GB Single-bank
1 GB 1 GB 2 GB Single-bank interleaved
2 GB 2 GB Single-bank
2 GB 2 GB 4 GB Single-bank interleaved
2 GB 2 GB 2 GB 6 GB Dual-bank asymmetric
2 GB 2 GB 2 GB 2 GB 8 GB Dual-bank interleaved
Heatsink
To remove the component:
1. Power down the server (on page 26).
2. Unlock the bezel (on page 27).
3. Remove the access panel ("Access panel" on page 28).
4. Disconnect the processor heatsink fan cable from the system board ("System board components" on
page 68).
5. Remove the heatsink.
CAUTION: Heatsink retaining screws should be loosened in diagonally opposite pairs (in an
"X" pattern).
Vista de pagina 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 79 80

Comentarios a estos manuales

Sin comentarios