HP 10TB Guía de usuario descargar pdf (Pagina 103)

Removing and replacing the front bezel (full)

NOTE: This full procedure is only required if all screws are not accessible due to the position of

the system in the rack.

Removing the front bezel (full)

1. Power off the system as described in “Powering the system off and on” (page 76).

2. Remove the enclosure from the rack as described in “Removing the system enclosure from the

rack” (page 83).

3. Pull the hard drive handle down 90 degrees, and slide out the hard drive drawer.

4. Remove all eight screws from the front bezel and pull the handle down 90 degrees (1, Figure 79

(page 103)). Then lift the front bezel up and out to remove the front bezel (2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

Figure 79 Removing the front bezel

Removing and replacing the front bezel (full) 103

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 180 181

Sin comentarios

HP 10TB Guía de usuario Pagina 103