
Replacing the power supply
1. Insert the replacement power supply.
2. Plug the power cord into the power supply.
3. Verify that the replacement component is working properly by checking the associated LED
status.
4. Confirm that the system has resumed normal operations.
Removing and replacing the HP Ethernet I/O module
Removing the HP Ethernet I/O module
1. Verify the failed component as described in “Verifying component failure” (page 82).
2. Label the cables, and then unplug all cables from the HP Ethernet I/O module.
3. Press the module release mechanism to the right (1, Figure 63 (page 94)), and then remove
the failed module (2).
Figure 63 Removing the HP Ethernet I/O module
Replacing the HP Ethernet I/O module
1. Insert the replacement HP Ethernet I/O module (Figure 64 (page 94)).
Figure 64 Replacing the HP Ethernet I/O module
2. Plug in all cables to the replacement module to their original locations.
94 Removing and replacing hardware components
Comentarios a estos manuales