HP A5799A Manual de usuario Pagina 96

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 166
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 95
86
LED Term. Server condition,
LED is on
Term. Server condition,
LED is off
ETHERNET RX
(amber)
Unit receiving data. Idle.
TX
(amber)
Unit transmitting data. Idle.
Determining Network Status
The
DNS
command displays the status of the network. If the network is
running, the following message appears:
The terminal server determines network status by detecting traffic on the
Ethernet link. The user sets the time interval for non-activity, which can
range from 1 to 255 seconds. Two alarms indicate network status: if
active the .NETUP alarm is issued, if inactive the .NETDOWN alarm is
issued.
An attempt at a Telnet connection into the terminal server results in no
response if the terminal server or network connection is down. A Sysop
session through the AUX port is the only way to restart or communicate
with the terminal server at this point.
NOTE: An Alarm/Event action routine must be created for these
alarms. Otherwise the unit will receive the alarm but will not know
what action to take.
To enter the time interval, type
SNP
1
at the prompt. At the Network-Loss
Alarm Delay Time, enter the time interval for non-activity on the network.
Vista de pagina 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 165 166

Comentarios a estos manuales

Sin comentarios