
3.1.2.2 Manual installation of the Sender on Windows
To install the Sender on Windows, log into an account with administrator privileges, and perform the
following steps:
1. Go to the directory where you downloaded RGS, and change to the directory win32\sender.
2. Double-click Setup.exe to start the Sender installation, and follow the instructions on the screen.
3. During the installation, the Remote Graphics Sender Configuration dialog is displayed (see
Figure
3-3 Dialog to enable or disable Remote USB in the Sender on page 55). Check the boxes
appropriate to your requirements, as follows:
●
Enable Remote USB—Check this box if USB devices attached to the Local Computer need
to be accessible by the Remote Computer. For further information, see
Remote USB overview
on page 28.
●
Enable Remote Microphone—Check this box to enable remote microphone. Remote
microphone is not supported on Microsoft Windows Vista and Windows 7 therefore; this
option is not available on Windows Vista and Windows 7. (see
Remote audio on page 36)
●
Enable Remote Clipboard—Check this box if your Local Users will need Remote
Clipboard capability. For further information, see
Remote Clipboard overview on page 42
●
I’m not sure, I want more information—For further information, check this box, and
click Next.
Figure 3-3 Dialog to enable or disable Remote USB in the Sender
ENWW
Installing RGS on Windows
55
Comentarios a estos manuales