HP Remote Graphics Software (RGS) Manual de usuario Pagina 97

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 259
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 96
When rgadmin is started, it reports the current status of Single Sign-on and Easy Login. To change the
status, check the desired radio button. After clicking Apply, Single Sign-on or Easy Login are
immediately available on Windows Vista and Windows 7.
Figure 3-23 Dialog to enable or disable Single Sign-on and Easy Login (Windows Vista and
Windows 7)
3.2 Installing RGS on Linux
This section describes how to:
Install and uninstall the RGS Receiver on Linux
Audio requirements for the Linux Receiver
Install and uninstall the RGS Sender on Linux.
NOTE: The RGS Sender uses TCP/IP port 42966. The Linux installer adds an iptables entry to open
this port.
3.2.1 Installing the Receiver on Linux
NOTE: Beginning with RGS 5.1.3, the Linux RGS Receiver is available in both 32-bit and 64-bit
versions.
To install the RGS Receiver on Linux, perform the following steps:
1. Login as root.
2. Go to the directory where you downloaded RGS, and change to the directory lin32/receiver (32-
bit version) or lin64/receiver (64-bit version).
ENWW
Installing RGS on Linux
79
Vista de pagina 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 258 259

Comentarios a estos manuales

Sin comentarios