HP StorageWorks 9030 Virtual Library System Manual de usuario descargar pdf (Pagina 117)

Figure 11 Create Virtual Library Wizard window (2 of 12)

7. Change the library name if you prefer. You can use letters, numbers, and underscores (no

blank spaces).

8. Enter the maximum number of cartridge slots that may be added to the library in the Maximum

Slots box.

The default values in the Maximum Slots box is based on the physical tape library you selected.

CAUTION: Changing the defaults can have unpredictable results if your backup application

expects a certain number of slots in a specific library type.

9. Enter the maximum number of input/export ports on which the library may be configured to

be visible in the Maximum Ports box.

10. Enter the maximum number of tape drives the library may contain in the Maximum Drives

box.

NOTE: The maximum values entered cannot be changed later. So, consider your potential

future requirements when entering values.

Not all of the tape drives and cartridges must be created at this time. You may add tape drives

later.

11. Click Next Step.

A window opens indicating that by default all libraries connected to the VLS have access to

all hosts.

12. Click Create Library.

A summary window opens and displays details about the library emulation created.

13. Choose one of the following options:

• To perform LUN mapping for the virtual library, click Map LUNs and proceed to “LUN

Mapping” (page 112) for further instructions.

• To continue creating the virtual library, click Create Tape Drives and proceed to “Creating

Tape Drives” (page 118).

• To exit the wizard, click Cancel.

The library is created but does not contain any tape drives or cartridges. You can add

tape drives and cartridges later.

Creating a Virtual Library 117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 267 268

Sin comentarios

HP StorageWorks 9030 Virtual Library System Manual de usuario Pagina 117