Hp 3PAR Remote Copy Software Manual de usuario descargar pdf (Pagina 176)

B.40

setrcopygroup

Remote Copy User’s Guide InForm OS Version 2.3.1

recover

Used for groups on which the failover operation has already been run. Changes

matching primary volume groups on the backup system to secondary volume groups

and then starts and synchronizes all groups.

restore

Used on groups on which the recover operation has already been run. Returns all

groups to their natural direction and starts them.

<group_name>

Specifies the name of the volume group whose policy is to be set, or whose target

designation is to be switched.

<target_name>

Specifies the target name for the target definition created with the creatercopytarget

command (see creatercopytarget on page B.20).

<period_value>s|m|h|d

Specifies the time period in units of seconds (s), minutes (m), hours (h), or days (d), for

automatic resynchronization (e.g.

14h for 14 hours). The time must be longer than or

equal to five minutes and not more than one year in duration, or set to zero to indicate

that no period should be used. This specifier can only be used with the

period

subcommand.

<mode_value>

Specifies the mode, sync or periodic, to which the group is set. This specifier can only be

used with the mode subcommand.

RESTRICTIONS

■ This command requires the 3PAR Remote Copy license. Contact your local service provider

for further information.

■ When issuing the setrcopygroup <dr_operation> command, either the

<group_name> specifier or the <target_name> specifier must be specified.

■ Reversing the direction of primary volumes will result in the loss of any data changed after

the group was stopped.

■ The period can be set only for groups whose mode is asynchronous periodic (see

creatercopygroup on page B.18).

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 343 344

Sin comentarios

Hp 3PAR Remote Copy Software Manual de usuario Pagina 176