Hp MPX200 Multifunction Router Manual de usuario descargar pdf (Pagina 57)

Specifies the site-local IPv6 address for the iSCSI port.-ipv6_site_addr=

Default is the current setting on the router.

Specifies the contact phone number.-phone=

Default is as currently set on the router.

Specifies the reply to email address for generated messages.-replyto_email=

Default is as currently set on the router.

Specifies the contact street address.-street=

Default is as currently set on the router.

Specifies the TCP port number on the mail server.-tcp_port=

Default is the current setting on the router.

Specifies the URL for HTTP notifications (if HTTP notifications are enabled).-url=

Example

c:\> rcli set notification -smtp1_ipv4_addr=10.0.0.14 /ip=10.0.0.12

[10.0.0.12]

Notification configuration set successfully

set ntp

The set ntp command sets the NTP server IP address and time zone offsets.

NOTE: If NTP is enabled, the -ntp_ipaddr keyword is required to ensure that at least one

valid NTP server address is present.

Syntax

set ntp

Keywords

Enables or disables NTP. Values are:-enable=

• yes

• no

• on

• off

• true

• false

If used to disable NTP, all current IP address settings are initialized and all other

keywords are ignored.

Default value as currently set on the router.

Specifies the array index for the NTP server address.-index=

The default value is 0.

Specifies the NTP server IPv4 or IPv6 address.-ntp_ipaddr=

The default is the current setting on the router.

Specifies the number of hours (-12 to 12) to offset for the time zone.-tz_hours=

The default is the current setting on the router.

Specifies the number of minutes (0–59) to offset the time zone.-tz_mins=

The default is the current setting on the router.

set ntp 57

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 119 120

Sin comentarios

Hp MPX200 Multifunction Router Manual de usuario Pagina 57