Hp MPX200 Multifunction Router Manual de usuario descargar pdf (Pagina 138)

6. Add FCoE targets to the FCoE zone.

After the first virtual disk/LUN is presented, the FCoE targets are dynamically created and

mapped. In Figure 116 (page 138), if move your cursor over the More icon, a Host Details

pop-up appears, showing the FCoE targets and how they map to the P6000 EVA ports. These

FCoE WWNNs must be added to the FCoE zone created in Step 3.

NOTE: This step is not required for subsequent Vdisk/LUN assignments for the same or

additional hosts.

Figure 116 Host Details display

Setting up FCoE connectivity to 3PAR arrays

Before executing the following procedure, ensure that MPX200 host has been created in the InForm

Management Console as described in “Managing MPX200 iSCSI for 3PAR StoreServ Storage”

(page 40).

To set up for FCoE:

1. Configure the FCoE-enabled converged network switch. Depending on the switch vendor, you

might need to configure the ports for FCoE use.

For information about switch setup, see the Fibre Channel Over Ethernet chapter of the HP

SAN Design Reference Guide, available at: http://www.hp.com/go/sdgmanuals.

2. Verify that the MPX200 10-GbE ports are connected to the FCoE switch as described in “FCoE

configurations” (page 133).

3. Set up the CNA:

a. Install the CNA driver kit.

b. Depending on the CNA vendor, use the available management tool to determine the

WWNN/WWPN for each port on the CNA.

For more information about CNA configurations, see the HP Emulex Converged Network

Adapter Installation Guide, available at http://bizsupport1.austin.hp.com/bc/docs/support/

SupportManual/c02018539/.

4. Create a zone with the MPX200 FCoE ports and the CNA on each fabric.

This registers the CNA worldwide name in the MPX200.

138 MPX200 FCoE feature description

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 257 258

Sin comentarios

Hp MPX200 Multifunction Router Manual de usuario Pagina 138