Hp MPX200 Multifunction Router Manual de usuario descargar pdf (Pagina 31)

4 Managing MPX200 iSCSI using HP P6000 Command

View

This chapter provides instructions for setting up the MPX200 management port, Fibre Channel

zoning, HP P6000 Command View discovery, setting up the iSCSI IP ports, and setting the date

and time.

NOTE: FCIP functionality is not configured using HP P6000 Command View. For configuration

requirements, see “MPX200 FCIP” (page 108).

Setting up the MPX200 management port

Most management functions have been built into HP P6000 Command View. In some cases, access

to the MPX200 CLI is required.

You connect to the CLI through one of the following:

• RS-232 serial port (115200/8/n/1)

• Telnet

• SSH

By default, the management port obtains a DHCP address. If the management port cannot obtain

a DHCP address, you must set a static IP address.

Fibre Channel zoning

Because the MPX200 can be a fabric-connected device, it is important to understand the zoning

requirements.

Open zoning

When using an open zone configuration, each FC port on each MPX200 must be connected to a

separate fabric (see “Open zone configuration” (page 31)).

Figure 18 Open zone configuration

CAUTION: HP recommends that you use zoning if the MPX is in a mixed environment with FC

initiators.

Setting up the MPX200 management port 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 257 258

Sin comentarios

Hp MPX200 Multifunction Router Manual de usuario Pagina 31