
Installation
47HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Applying Power to the Library
To apply power to the library (see Figure 16):
1. Connect each supplied power cord 1 to each power supply receptacle.
Note: The left-hand AC power receptacle is for the bottom power supply. The
right-hand AC receptacle is for the top power supply. (four-drive models only).
2. Toggle each power switch 2 on.
Note: You can remove the appliqué from the GUI touch screen by catching one corner
and carefully lifting it.
3. Press anywhere on the graphical user interface (GUI) touch screen 3 to
activate the display and turn the library on.
Note: The SCSI terminator must always be connected to the library controller board for
proper operation if the library is configured as a master or standalone.
Comentarios a estos manuales