HP EliteDesk 705 G3 Small Form Factor PC Manual de usuario descargar pdf (Pagina 21)

Installing additional memory

The computer comes with double data rate 4 synchronous dynamic random access memory (DDR4-SDRAM)

dual inline memory modules (DIMMs).

DIMMs

The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These

memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory

support, you can populate the system board with up to 64 GB of memory congured in a high-performing

dual channel mode.

DDR4-SDRAM DIMMs

For proper system operation, the DIMMs must be:

●

industry-standard 288-pin

●

unbuered non-ECC PC4-17000 DDR4-2133 MHz-compliant

●

1.2 volt DDR4-SDRAM DIMMs

The DIMMs must also:

●

support CAS latency 15 DDR4 2133 MHz (15-15-15 timing)

●

contain the mandatory JEDEC SPD information

In addition, the computer supports:

●

512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies

●

single-sided and double-sided DIMMs

●

DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported

NOTE: The system will not operate properly if you install unsupported DIMMs.

Populating DIMM sockets

There are four DIMM sockets on the system board, with two sockets per channel. The sockets are labeled

DIMM1, DIMM2, DIMM3, and DIMM4. Sockets DIMM1 and DIMM2 operate in memory channel B. Sockets DIMM3

and DIMM4 operate in memory channel A.

The system will automatically operate in single channel mode, dual channel mode, or ex mode, depending

on how the DIMMs are installed.

NOTE: Single channel and unbalanced dual channel memory congurations will result in inferior graphics

performance.

●

The system will operate in single channel mode if the DIMM sockets are populated in one channel only.

●

The system will operate in a higher-performing dual channel mode if the total memory capacity of the

DIMMs in Channel A is equal to the total memory capacity of the DIMMs in Channel B. The technology and

device width can vary between the channels. For example, if Channel A is populated with two 1 GB

DIMMs and Channel B is populated with one 2 GB DIMM, the system will operate in dual channel mode.

●

The system will operate in ex mode if the total memory capacity of the DIMMs in Channel A is not equal

to the total memory capacity of the DIMMs in Channel B. In ex mode, the channel populated with the

least amount of memory describes the total amount of memory assigned to dual channel and the

remainder is assigned to single channel. For optimal speed, the channels should be balanced so that the

Installing additional memory 15

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Comentarios a estos manuales

Sin comentarios

HP EliteDesk 705 G3 Small Form Factor PC Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para No HP EliteDesk 705 G3 Small Form Factor PC