
28
Note:
The power cords of the MCS 5042 are 4 m (13.1 feet) long. After the
cords are connected to the MCS 5042 and routed down the rear of the IT
rack, approximately 2 m (6.6 feet) will be left to connect to the power
source.
When using only a single (primary) source for power, the AC power cord is connected to the left-most
receptacle (when viewed from the rear of the cabinet, labeled as AC1) as shown in Figure 18.
Figure 18: Single-source AC power connection
When redundant AC power is available, the redundant AC power cord is connected to the right
receptacle (labeled as AC2) as shown in Figure 19.
Figure 19: Redundant-source AC power connection
Comentarios a estos manuales