HP RP7 Retail System Model 7100 Manual de usuario descargar pdf (Pagina 30)

6 Operating modes

Scan mode

The scanner can be set to operate in one of several scanning modes. See the HP Wireless Barcode Scanner

Programming Reference Guide (PRG) for more information and settings for any of the options.

Trigger Single (default): This mode is associated with typical handheld scanner operation. Motion Sense is

active and if the scanner detects motion the aiming pattern is turned on. When the trigger is pulled,

illumination is turned on and the scanner attempts to read a label. Scanning is activated until one of the

following occurs:

●

The programmable “maximum scan on time”

has elapsed

●

A label has been read

●

The trigger is released

Trigger Pulse Multiple: Scanning begins when the trigger is pulled and continues after the trigger is released,

until the trigger is pulled again or until the programmable “maximum scan on time”

has elapsed. Reading a

label does not disable scanning. Double Read Timeout

prevents undesired multiple reads while in this mode.

Trigger Hold Multiple: When the trigger is pulled, scanning starts and the product scans until the trigger is

released or “maximum scan on time”

has elapsed. Reading a label does not disable scanning. Double Read

Timeout

prevents undesired multiple reads while in this mode.

Always On: The illuminator is always ON and the scanner is always ready for code reading. Double Read

Timeout

prevents undesired multiple reads.

Flashing: The scanner illuminator ashes on and o regardless of the trigger status. Code reading takes place

only during the Flash On

time. Double Read Timeout

prevents undesired multiple reads.

See the PRG for these and other programmable features.

Controlled by Flash On Time and Flash O Time. Use the PRG to program these options.

Stand Mode: In Stand Mode, the illumination remains on for a congurable amount of time after a good read

occurs. The scanner exits stand mode when movement is detected. If the trigger is activated from Stand

Mode, the scanner transitions into one of the triggered modes.

Pick Mode: Species a Decoding and Transmission process where barcodes that are not within the

congurable distance from the center of the aiming pattern are not acknowledged or transmitted to the host.

Pick Mode is active only while the scanner is in Trigger Single mode. If the scanner switches to a dierent

Read Mode, Pick Mode is automatically disabled.

Enter/Exit Programming Mode

Scan Mode = Trigger Single

24 Chapter 6 Operating modes

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Comentarios a estos manuales

Sin comentarios

HP RP7 Retail System Model 7100 Manual de usuario Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Lectores De Códigos De Barras HP RP7 Retail System Model 7100