
C H A P T E R 5 HP Multi-Site Traffic Director Server Appliance SA9200 User Guide
56
• Serial terminal emulation program such as Terminal or
HyperTerminal* for Windows* NT or HyperTerminal for
Windows 95 or 98.
• Cable and connector to match male DTE connector (DB-9).
Accessing the Boot Monitor
NOTE: After configuring
the SA9200 in the Boot
Monitor, you must enable
autoboot for the device to
boot into normal
operating mode.
To access the Boot Monitor Command Line Interface, interrupt the
boot sequence by pressing a key at the following prompt:
Press any key to stop autoboot
In a few seconds the following prompt appears, confirming that the
Boot Monitor is running:
monitor>
Comentarios a estos manuales