Hp Netserver L Server series Manual de usuario descargar pdf (Pagina 133)

Chapter 13 Alternative Rack Mounting (4–Post)

127

Attaching the Cable Management Arm

The Cable Management Arm (CMA) allows the cables and power cord to move in

and out with the HP Netserver chassis without being accidentally disconnected.

The Cable Management Arm installation is tool-less.

1. Ensure the HP Netserver is pushed all the way into the rack.

2. Attach the Cable Management Arm to the rack:

a. Attach the clip nuts to the 1st and 2nd holes of the rear right column

(counting from the base of the HP Netserver). See Figure 13-9.

b. Insert the outer flange thumbscrew into the 2nd hole, and tighten it.

c. Insert the screw into the 1st hole, and tighten it using the Torx driver.

Figure 13-9. Attaching the Cable Management Arm

3. Attach the Cable Management Arm to the HP Netserver:

a. Insert the inner flange thumbscrew into the hole in the chassis slide mount.

See Figure 13-9.

b. Tighten the thumbscrew to secure the Cable Management Arm.

4. Extend the HP Netserver out of the rack to ensure the Cable Management

Arm moves with the chassis without binding.

5. Plug the HP Netserver’s power cable and any data cables into the back of the

HP Netserver.

6. Dress the cables in the Cable Management Arm, and then slide the HP

Netserver into the rack to verify that the cables do not bind in the tray.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 145 146

Sin comentarios

Hp Netserver L Server series Manual de usuario Pagina 133