
Hardware options installation 34
2.
Prepare the drive.
3. Install the drive.
4. Determine the status of the drive from the drive LED definitions ("Hot-plug drive LED definitions" on page
13).
Mini-SAS cable option
To connect the cable option:
1. Power down the server (on page 16).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 16).
o Remove the server from the rack (on page 17).
4. Remove the access panel (on page 18).
5. Remove the PCI riser cage (on page 20).
Comentarios a estos manuales