Hp ProLiant DL320e Gen8 Server Manual de usuario descargar pdf (Pagina 46)

Hardware options installation 46

Memory channel 1 consists of the two DIMMs that are closest to the processor.

o Memory channel 2 consists of the two DIMMs that are located farthest from the processor.

• White DIMM slot indicate the first slot of a channel (3-A, 1-B).

• Memory speed support depends on the type of processor installed. See the technical specification of the

installed processor for more information.

• The server supports up to 1600 MT/s ECC UDIMMs.

• The server supports up to 32 GB (4x8 GB) UDIMMs.

• The server does not support:

o RDIMMs

o Non-ECC UDIMMs

o Elpida DIMMs

• When installing DIMMs:

o Populate the DIMM slots in this sequence: 3-A, 1-B, 4-C, 2-D.

o Use HP-qualified UDIMMs.

For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool

on the HP website (http://www.hp.com/go/ddr3memory-configurator).

Installing a DIMM

1. Power down the server (on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

o Extend the server from the rack (on page 16).

o Remove the server from the rack (on page 17).

4. Remove the access panel (on page 18).

5. Remove the air baffle.

6. Open the DIMM slot latches.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 95 96

Sin comentarios

Hp ProLiant DL320e Gen8 Server Manual de usuario Pagina 46