Hp ProLiant DL320s Server Manual de usuario descargar pdf (Pagina 32)

Hardware options installation 32

Installing the PCI riser board assembly

CAUTION: To prevent damage to the server or expansion boards, power down the server and

remove all AC power cords before removing or installing the PCI riser board assembly.

1. Power down the server (on page 26).

2. Remove the access panel ("Removing and replacing the access panel" on page 26).

3. Remove the upper tray ("Removing the upper tray" on page 27).

4. Install the expansion board ("Installing an expansion board" on page 34).

5. Install the PCI riser board assembly in the server, and tighten the thumbscrews.

6. Replace the upper tray ("Removing the upper tray" on page 27).

7. Replace the access panel ("Removing and replacing the access panel" on page 26).

Hard drive options

The server supports up to 12 SAS or SATA hard drives. Always populate hard drive bays starting with the

lowest device number ("SAS and SATA drive numbers" on page 8).

SAS and SATA hard drive guidelines

When adding hard drives to the server, observe the following general guidelines:

• The system automatically sets all device numbers.

• If only one hard drive is used, install it in the bay with the lowest device number.

• Drives must be the same capacity to provide the greatest storage space efficiency when drives are

grouped together into the same drive array.

NOTE: ACU does not support mixing SAS and SATA drives in the same logical volume.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Sin comentarios

Hp ProLiant DL320s Server Manual de usuario Pagina 32