Hp ProLiant DL320s Server Manual de usuario descargar pdf (Pagina 38)

Hardware options installation 38

13. Replace the access panel ("Removing and replacing the access panel" on page 26).

After installing a battery pack, you might see a POST message during reboot, indicating that the array

accelerator (cache) is temporarily disabled. This behavior is normal because the new battery pack is likely

to have a low charge. You do not need to take any action because the recharge process begins

automatically when the battery pack is installed. The controller will operate properly while the battery

pack recharges, although the performance advantage of the array accelerator will be absent. When the

battery pack has been charged to a satisfactory level, the array accelerator is automatically enabled.

Installing a DVD-ROM drive assembly

1. Remove the server from the rack.

2. Remove the access panel ("Removing and replacing the access panel" on page 26).

3. Remove the upper tray ("Removing the upper tray" on page 27).

4. Install the DVD-ROM assembly into the server. and tighten the thumbscrews as shown.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Sin comentarios

Hp ProLiant DL320s Server Manual de usuario Pagina 38