
Hardware options installation 55
Retain the blank for future use.
5. Remove the access panel (on page 23).
6. Remove the air baffle (on page 24).
7. Remove the primary PCI riser cage ("Remove the PCI riser cages" on page 25).
8. Install the optical drive into the bay.
9. Connect the optical drive cable to the optical drive.
10. Route the optical drive cable along the side of the system board, and then connect the cable to the
system board.
11. Install the primary PCI riser cage ("Install the PCI riser cages" on page 26).
12. Install the air baffle (on page 24).
13. Install the access panel (on page 24).
14. Install the server into the rack ("Installing the server into the rack" on page 33).
15. Power up the server (on page 20).
Hot-plug fan module option
To provide sufficient airflow to the system if a primary fan fails, the server supports redundant fans.
Comentarios a estos manuales