Hp ProLiant DL580 Gen8 Server Manual de usuario Pagina 51

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 50
Hardware options installation 51
Do not mix LRDIMMs and RDIMMs.
UDIMMs are not supported on this server.
When multiple processors are installed, HP recommends installing the DIMMs in sequential
alphabetical order: 4A, 9B, 1C, 12D, and so on.
For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool
on the HP website (http://www.hp.com/go/ddr3memory-configurator).
DIMM speeds are supported as indicated in the following table.
Populated slots
(per channel)
Rank Speeds supported (MT/s)
1
Single- or dual-rank 1333
1
Quad-rank 1600
2
Single- or dual-rank 1066, 1333
2
Quad-rank 1600
3
Single- or dual-rank 1066
3
Quad-rank 1333
Advanced ECC population guidelines
For Advanced ECC mode configurations, observe the following guidelines:
Observe the general DIMM slot population guidelines.
DIMMs may be installed individually. HP recommends installing DIMMs in pairs.
Online spare population
For Online Spare memory mode configurations, observe the following guidelines:
Observe the general DIMM slot population guidelines.
Each channel must have a valid online spare configuration.
Each channel can have a different valid online spare configuration.
Each populated channel must have a spare rank:
o A single dual-rank DIMM is not a valid configuration.
o LRDIMMs are treated as dual-rank DIMMs.
Installing a DIMM
WARNING: Use caution when installing or removing the processor memory drawer. The
processor memory drawer is very heavy when fully populated.
To install the component:
1. Power down the server (on page 23).
2. Remove all power:
a. Disconnect each power cord from the power source.
Vista de pagina 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 108 109

Comentarios a estos manuales

Sin comentarios