Hp ProLiant ML350 G5 Server Manual de usuario descargar pdf (Pagina 39)

Hardware options installation 39

NOTE: Depending on model purchased, the server may look slightly different than shown.

SATA or SAS hard drive option

IMPORTANT: When installing a x3/x1 SAS cable in a SFF system, HP recommends that the x3

part of the x3/x1 cable be linked to the SAS hard drive backplane connector that corresponds

to hard drive slots 1 to 4. In this setup, hard drive slot 1 will not be available, but since hard

drive slots 2 to 4 will be connected, one continuous volume can be created. All drive slots will

be available in LFF systems.

To install the component:

1. Open the bezel (tower model) ("Open or remove the tower bezel" on page 18).

2. Remove the existing hard drive blank (on page 38).

NOTE: Depending on model purchased, the server may look slightly different than shown.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 117 118

Sin comentarios

Hp ProLiant ML350 G5 Server Manual de usuario Pagina 39