Hp ProLiant ML350 G5 Server Manual de usuario Pagina 72
- Pagina / 118
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Configuration and utilities 72
• Send alerts from iLO 2 regardless of the state of the host server.
• Access advanced troubleshooting features through the iLO 2 interface.
• Diagnose iLO 2 using HP SIM through a web browser and SNMP alerting.
For more information about iLO 2 features, refer to the iLO 2 documentation on the Documentation CD or
on the HP website (http://www.hp.com/servers/lights-out
).
System Online ROM flash component utility
The Online ROM Flash Component Utility enables system administrators to efficiently upgrade system or
controller ROM images across a wide range of servers and array controllers. This tool has the following
features:
• Works offline and online
• Supports Microsoft® Windows NT®, Windows® 2000, Windows Server™ 2003, Novell Netware,
and Linux operating systems
IMPORTANT: This utility supports operating systems that may not be supported by the server.
For operating systems supported by the server, see the HP website
(http://www.hp.com/support
).
• Integrates with other software maintenance, deployment, and operating system tools
• Automatically checks for hardware, firmware, and operating system dependencies, and installs only
the correct ROM upgrades required by each target server
To download the tool and for more information, see the HP website (http://www.hp.com/support
).
Erase Utility
CAUTION: Perform a backup before running the System Erase Utility. The utility sets the system
to its original factory state, deletes the current hardware configuration information, including
array setup and disk partitioning, and erases all connected hard drives completely. Refer to the
instructions for using this utility.
Run the Erase Utility if you need to erase the system for the following reasons:
• You want to install a new operating system on a server with an existing operating system.
• You want to change the operating system selection.
• You encounter a failure-causing error during the SmartStart installation.
• You encounter an error when completing the steps of a factory-installed operating system installation.
The Erase Utility can be accessed from the Software and Drivers Download website
(http://www.hp.com/go/support
) or the Maintenance Utilities menu of the SmartStart CD ("SmartStart
software" on page 67).
Management Agents
Management Agents provide the information to enable fault, performance, and configuration
management. The agents allow easy manageability of the server through HP SIM software, and third-
party SNMP management platforms. Management Agents are installed with every SmartStart assisted
- User Guide 1
- Audience assumptions 2
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- Front panel LEDs and buttons 8
- Rear panel components 9
- Rear panel LEDs and buttons 10
- System board components 11
- NMI jumper 12
- System maintenance switch 12
- System board LEDs 13
- SAS and SATA hard drive LEDs 15
- Online/activity 16
- LED (green) 16
- Fault/UID LED 16
- (amber/blue) 16
- Interpretation 16
- Operations 17
- Remove the access panel 19
- Install the access panel 20
- Optimum environment 21
- Temperature requirements 22
- Power requirements 23
- Rack planning resources 24
- Rack warnings 24
- Installing hardware options 25
- Setting up a tower server 25
- Registering the server 28
- Introduction 29
- Processor option 29
- Memory options 36
- Installing FBDIMMs 37
- Hard drive blank 38
- Identifying guide screws 42
- Installing a diskette drive 45
- Expansion board options 48
- PCI-X expansion cage option 52
- Cabling 65
- Cabling 66 66
- Configuration and utilities 67
- ROM-Based Setup Utility 68
- Array Configuration Utility 69
- Management tools 71
- Erase Utility 72
- Management Agents 72
- HP Systems Insight Manager 73
- Redundant ROM support 73
- Diagnostic tools 74
- Keeping the system current 75
- ProLiant Support Packs 76
- Care Pack 76
- Troubleshooting 77
- Symbols on equipment 78
- Warnings and cautions 78
- Symptom information 79
- Loose connections 80
- Service notifications 81
- Troubleshooting flowcharts 81
- General diagnosis flowchart 82
- Symptoms: 84
- Troubleshooting 86 86
- POST problems flowchart 87
- OS boot problems flowchart 88
- • Redundancy failure 91
- Troubleshooting 92 92
- • Install a power supply 93
- Battery replacement 94
- Battery replacement 95 95
- FCC rating label 96
- Class A equipment 96
- Class B equipment 96
- Modifications 97
- • EMC Directive 2004/108/EC 98
- Japanese notice 99
- BSMI notice 99
- Korean notice 99
- Laser compliance 100
- Battery replacement notice 100
- Electrostatic discharge 102
- Server specifications 103
- Specification Value 104
- Technical support 105
- Customer Self Repair 106
- Technical support 108 108
- Reparo feito pelo cliente 110
- Technical support 111 111
- Technical support 112 112
- Acronyms and abbreviations 113
- Systems Insight Manager 115
- Index 116 116
- Index 117 117
- Index 118 118
Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant ML350 G5 Server
(135 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.128 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales