Hp ProLiant WS460c G6 Workstation-Blade Manual de usuario Pagina 41

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 40
Hardware options installation 41
Do not install DIMMs in channel 3 for any processor.
DIMM configuration on channel 1 and channel 2 of a processor must be identical.
In multiprocessor configurations, each processor must have a valid Lockstep Memory configuration.
In multiprocessor configurations, each processor may have a different valid Lockstep Memory
configuration.
Single-processor Lockstep population order
For Lockstep memory mode configurations with a single processor, populate the DIMM slots in the following
order:
RDIMM
o First: A and B
o Next: D and E
o Do not populate slots C or F.
UDIMM
o First: A and B
o Last: D and E
o Do not populate slots C or F.
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support ("Configuring
lockstep memory" on page 58).
Multi-processor Lockstep population order
For Lockstep memory mode configurations with multiple processors, populate the DIMM slots for each
processor in the following order:
RDIMM
o First: A and B
o Next: D and E
o Do not populate slots C or F.
UDIMM
o First: A and B
o Last: D and E
o Do not populate slots C or F.
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support ("Configuring
lockstep memory" on page 58).
Installing a DIMM
CAUTION: To avoid damage to the hard drives, memory, and other system components, the air
baffle, drive blanks, and access panel must be installed when the server is powered up.
Vista de pagina 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 108 109

Comentarios a estos manuales

Sin comentarios