HP RM500SL Manual de usuario descargar pdf (Pagina 24)

0611 RM500SL User’s Guide Version 2.8 Page 24

5.4 Single computer connection

FastFacts 5.4: Single computer connection

The computer must be running Windows 95 or higher, with a functioning network

card connected to one port on a Ethernet network hub or switch. Connect a Cat

5, RJ-45 cable from a hub port to the RM500SL connector. To set up the PC:

1) Right click Network Neighborhood (or My Network Places) & select Properties.

2) Right click Local Area Network Connection & select Properties.

3) If Internet protocol TCP/IP is not installed, install it from your Windows disk.

4) Highlight Internet Protocol (TCP/IP) & select the Properties button.

5) Check “Use the following IP address” and enter the following in the IP address

box: 172. 30. 1. 1. Enter 255. 255. 255. 0 in the Subnet mask box.

On the RM500SL, see

5.3 Networking setup

and manually configure

as shown:

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 111 112

Sin comentarios

HP RM500SL Manual de usuario Pagina 24