HP HyperFabric Manual de instalación descargar pdf (Pagina 65)

Installing HyperFabric

Installing the Software

Chapter 3

• hp-clic 3384/udp #clic switch management

Note that these lines are used by the HyperFabric software—and are not comments—so

do not remove them from the file.

Step 14. Verify that all installed HyperFabric adapters have a software state of “CLAIMED,” by

running the ioscan -nf -C clic command.

Note: A check is also done to make sure all of the HyperFabric adapters have been

claimed when clic_init is activated or when SAM is used to configure HyperFabric.

Step 15. If one or more HyperFabric switches are included in the configuration, go to the next

section of this chapter, “Installing HyperFabric Switches”, otherwise, go to Chapter 4,

“Configuring HyperFabric,” on page 83.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 155 156

Sin comentarios

HP HyperFabric Manual de instalación Pagina 65