HP HyperFabric Manual de instalación descargar pdf (Pagina 69)

Installing HyperFabric

Installing HyperFabric Switches

Chapter 3

Step 2. Install and secure the rails in the rack, using two screws per rail. The figure below shows

the rack with the rails installed.

Step 3. From the front of the rack, install a bracket on the outside of each rail, using two screws

per bracket. Be sure to use the upper screw holes on each bracket. Put the screws in the

second and third square holes—counting away from yourself—in each rail. Do not

tighten the screws. These brackets—referred to as “bracket 1” and “bracket 2” in these

steps—will secure the front of the switch. The following figure shows the rack with these

two brackets installed.

screws

front

back

rack

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 155 156

Sin comentarios

HP HyperFabric Manual de instalación Pagina 69