HP 100VG-ANYLAN B5426-90001 Manual de usuario descargar pdf (Pagina 20)

20 Chapter1

Installation Procedure

4. Attach the Adapter to the Network

Use the RJ-45 connector for connecting a UTP category 3 or 5 cable

(not supplied) to a 100VG-AnyLAN hub or 10Base-T hub/switch. Refer to

Figure 1-3..

Figure 1-3 Port Connection

Attach the cable to the RJ-45 connector by following these steps:

a. Plug the cable into the RJ-45 connector.

b. Secure the other end of the cable to the 100VG-AnyLAN hub or

10Base-T hub/switch.

c. If necessary, reconﬁgure the hub/switch port to operate at the desired

speed and duplex settings.

NOTE

All of the LEDs on the adapter (except the Power LED) are initialized by

software when the link is started on the system. Therefore, until

software initializes the adapter, the state of the LEDs cannot be reliably

interpreted.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 38 39

Sin comentarios

HP 100VG-ANYLAN B5426-90001 Manual de usuario Pagina 20