HP 100VG-ANYLAN B5426-90001 Manual de usuario descargar pdf (Pagina 26)

26 Chapter2

Service Information

Troubleshooting Tools

Table 2-1 Troubleshooting Checklist

LED state Possible cause Solution

Power LED off No power applied to card Check power to HP-PB bus/system,

verify adapter is properly seated in

its slot.

Blown fuse Replace the adapter

Test LED on Driver has detected a fatal

hardware or software condition

Consult console and/or log ﬁles for

error messages. Retry the

operation. If necessary, contact HP

or replace the adapter.

Link LED off Card is not receiving link signals

from hub/switch

Verify link has been started by the

operator. If so, verify proper

conﬁguration of the link and the

hub/switch port. Check/replace the

cable.

Activity LED off Card is not sending or receiving

data to/from the hub/switch

This condition is normal when the

link LED is off or when the hub is

not sending or receiving data

to/from the adapter. If you believe

data is being sent/received, check

the hub/switch port conﬁguration,

and also the network and/or MAC

address conﬁguration for the link.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 38 39

Sin comentarios

HP 100VG-ANYLAN B5426-90001 Manual de usuario Pagina 26