HP 100VG-ANYLAN B5426-90001 Manual de usuario descargar pdf (Pagina 22)

22 Chapter1

Installation Procedure

6. Verify Operation

Verify proper operation of the HP-PB 100VG-AnyLAN Network Adapter

by checking the LEDs on the card. When the computer is switched on,

the Power LED will come on. At this point, the rest of the LEDs are in an

uninitialized state, and cannot be used until the driver on the system has

been started. After the driver has been started, the following Table 1-1,

may be used to interpret the LED patterns.

Table 1-1 LED Patterns

LED LED on LED off

Test Driver has detected a

fatal condition and is no

longer operating.

Adapter is functioning

correctly.

10 Adapter is operating at

10Mbps.

Adapter is not operating at

10Mbps.

100 Adapter is operating at

100Mbps.

Adapter is not operating at

100Mbps.

Link Adapter is correctly

receiving a link signal

from the hub/switch.

Adapter is not receiving a

link signal from the

hub/switch.

Activity Adapter is sending or

receiving a packet to/from

the hub/switch.

No packet is currently being

transferred to/from the

hub/switch.

Power Adapter is receiving

power from the system.

The system is not supplying

power, or the adapter is not

seated properly in the slot.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 38 39

Sin comentarios

HP 100VG-ANYLAN B5426-90001 Manual de usuario Pagina 22