HP 24S Guía de usuario descargar pdf (Pagina 31)

AUI Port

Caution

Do not touch the hub connector pins or the cable connector pins. Static

discharge may damage the equipment.

1. Disable the SQE Test (signal

quality error, or “heartbeat”, test signal)

and Loopback Test options, if present

on the transceiver. See Note below.

2. Slide the AUI retainer (included)

onto the connector posts on the

transceiver or AUI cable.

3. Plug the transceiver or AUI cable

into the AUI port on the hub and

secure it with the retainer’s screws.

Tighten the screws until they are snug;

do not over tighten them.

4. Attach the network cable to the transceiver.

Note

Disable SQE Test on Transceiver.

Any transceiver used with this hub must allow disabling the SQE test.

An HP 28641A ThinMAU does not meet this requirement and cannot be

used. Instead use an HP 28641B ThinLAN Transceiver.

Similarly, an HP 30241A ThickMAU with date code D-3017 or earlier

cannot be used. (The date code is found on a small white sticker on the

body of the device. Lower numbers indicate an earlier manufacturing

date.) Instead, use an HP 30241A with date code F-3105 or later, and

follow the instructions that are included with the ThickMAU for disabling

SQE test.

AUI port on hub

Transceiver or AUI

cable

AUI retainer

Installation 2-13

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 101 102

Sin comentarios

HP 24S Guía de usuario Pagina 31